Pressure Washer Pull Cord Will Not Start

After that with each consecutive pull it will be even harder and soon enough the cord will break under the pressure.

Pressure washer pull cord will not start.

The solution to this is to use a carburetor cleaning agent. Remove the spark plug and then pull the starter rope to see if the engine spins. If the pressure washer does not start on that first pull you will be adding more and more with each pull. When a pressure washer pull cord snaps on a job it is a real pain.

The carburetor might be clogged. A clogged carburetor is most commonly caused by leaving fuel in the pressure washer for a long period of time. Flushing the carburetor out with a special cleaning agent should remove the residue and allow the power washer to start. Honda power washer when you shut down your presure washer the pump makes pressure before y.

This pressure washer had a stuck pull rope. If you tipped the pressure washer on its side recently oil may have filled the cylinder preventing the engine from spinning. If the starter rope won t budge when you try to pull it the engine may be locked up or the recoil starter may have failed. Took a look at the pull rope assembly to see what was jammed or bent or broken.

The end result is a carburetor that does not work and a pressure washer that does not start. Pressure washer pull cord locked up honda gcv160 won t pull stuck. This sticky fuel can clog up the carburetor and prevent the engine from starting.